Ginkgoem Blog
Welcome to Ginkgoem
By ginkgoem | 17 May 2021 | 0 Comments

What should I do if there is a problem with the Ginkgoem engraving machine

maintenance:
For the maintenance and maintenance of the laser engraving machine in use, the following operations are recommended:
1. When the machine runs continuously for more than 10 hours, immediately shut down for maintenance to ensure the cleanliness of the cooling water and the normal operation of the water pump. Never make the water spindle motor lack water. Replace the cooling water regularly to prevent water temperature. Too high. If the working environment temperature is too low in winter, the water in the water tank can be replaced with antifreeze.
2. After the machine is used, be sure to clean up the dust on the platform and transmission system, and lubricate the transmission system regularly. (Note: The three-axis polished rod is maintained with oil; the screw part is added with high-speed butter)
3. When performing maintenance and inspection on the circuit part, be sure to cut off the power supply before proceeding.
4. The laser engraving machine cutting machine should be used for about three months to check the fasteners, and tighten the connecting screws on both sides of the gantry, the fastening screws of the screw nuts, and the fastening screws of the motors on both sides.

service
When the engraving machine does not work normally, it may be caused by a problem with its internal components or other reasons. The following is a general introduction to the frequently occurring problems.
(1) One of the three axes cannot move. At this time, check whether the drive block corresponding to the corresponding axis is damaged. The inspection method can use the replacement method: unplug the aviation plug corresponding to the fixed shaft and plug it into the drive corresponding to the other active shaft.
(2) If the immovable shaft moves normally after the exchange, it can indicate that the drive block corresponding to the shaft has been damaged and the drive block needs to be replaced. If the shaft still does not move, it means that the cable or motor is faulty. Replace the cable or motor.
(3) If none of the three shafts can be moved, check whether the three-axis aviation plug has been connected to the control box and whether the power of the control box has been turned on. Whether the data line is well connected with the control box and the control card in the host computer. If all of the above are normal and the machine still fails to run, please contact us. https://www.ginkgoem.com/

As a manufacturer of precision machinery and equipment, Ginkgoem can provide customers with a series of equipment such as reflow soldering machines, placement machines, solder paste printers and laser engraving machines in the SMT field. If you are interested, please feel free to contact us. https://www.ginkgoem.com/products/engraving-machine-gk-k3020

Leave a Reply

Your email address will not be published.Required fields are marked. *
Name
E-mail
Content
Verification code